COMPOSITE PLUG
10K - 350 DEGREES F

The Composite Plug was designed to provide an economical means of isolating multiple-stage casing fracs while facilitating a very short drill time to remove the plugs after the frac.

The Composite Plug is manufactured in two configurations; a Bridge Plug, and a flow back Frac Plug. Modified versions are also available. Each is typically set with a conventional Wireline setting tool.

The Bridge plug can hold differential pressure from both directions and is typically run as the top plug so that the well is dead when the tubing is stripped into the well to drill up the plugs.

The Frac Plug will hold pressure from above, but will allow upward flow back when the pressure is greater from below. This is accomplished by an internal ball and seat.

FEATURES

• Different colored composite material to ensure the appropriate differential pressure and temperature rating is run in the well.
• The plug’s bottom is slotted to prevent spinning during drilling operations. The slotted bottom mates with the plug’s top mandrel flats to prevent spinning when multiple plugs are stacked in the well.
• Standard 90-70-90 durometer, Nitrile multiple packing element system. Viton elastomers (400 degrees) available upon request.
• Drillable cast iron slips.
• Drillable aluminum mandrel.
• Can be milled or drilled with tubing or coiled tubing.
• Can be set on Wireline, tubing, or coiled tubing.